Electronics > Repair
SMD Component Identification Help
(1/2) > >>
Testtech:
Greetings,

I am working on an RF circuit and have encountered SMD components that I do not recognize. Please see the picture. I have outlined the four parts in question.
They have white translucent bodies, no marking other than the partial black band.
Resistance measured across these varies, and I suspect that the reading are from other circuit DC paths. I suspect capacitors.

Does anyone know for certain?

Thank you!
fzabkar:
The unmarked ones look like chip inductors. If so, then they should measure close to zero ohms.
Testtech:
I don't think they are inductors, as some measure in the 1000's of ohms, and other do not.
fzabkar:
Precision resistors?
Testtech:
fzabkar,

You are correct, these are inductors!
 I am in the process of working out exactly what is going on. Some of these components have clearly failed open circuit. Unfortunately, there are no value markings, so I am not sure how to estimate the correct values.
Some are in the signal path, (3-4 GHz), others seem to be bias filters for the transistor gain stages.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod