Electronics > Repair

Solartron 7061 7.5 Digits Multimeter Teardown and Repair

<< < (5/9) > >>

Kosmic:
D301A is the voltage reference

Kosmic:
The original Fischer connectors being way too expensive, I decided to replace them by cheap XLR 12mm 5 pins connectors I found on ebay. I know they are probably not that good but I wanted the opportunity to create a lot of different test leads for the 2 meters I have.





At least they are fitting on the existing front panel without any modifications.

Kosmic:
Back connectors for rear input and secondary input channel were also replaced.

Kosmic:
Unit #1 fully reassembled.




eevcandies:
I have one of these 7061 models, been sitting around at least 12 years, since I plugged in (It came up and ran fine last time).  I didn't have any way of make any connections to try it out (where are the banana jacks?), so I tossed it aside & reverted to my fluke meter.  I seem to remember not liking the readout, it put commas in the readings (like  12,437 V)?  Or perhaps I didn't fiddle enough with it.

I have a precision R6871E, which is nice, but I still use my Fluke! 

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod