EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: ksb on July 31, 2017, 09:14:13 am
-
Hi everyone. I am new to this group :). Currently im repairing a
SSPA (Solid State Power Amplifier)Paradise Datacom model HPAC2200XXXXX which having faulty and the alarm stated "Low DC Current alarm". This alarm trigger only when the M&C cable is connected to J4 (means when the amplifier is in enable mode).
Does anyone of you know which part/component cause this fault.
thank you,
Regards,
Alan.