Electronics > Repair
Strange problem on tds3054b
(1/4) > >>
pasta2018:
Recently i have got a tds3054b,it can pass selftest and spc.However, for each channel when vertical range is 1v/div or up,there is clutter ,each channel is the same. when the range is 500mV or below, it is ok. I checked the ±5V and ±15V is stable and correct.
pasta2018:
I take some photo
inse:
Is the phenomenon also visible with 50Ohm termination enabled at the inputs?
pasta2018:
yes,and AC/DC model also the same
pasta2018:
sometimes,it can not pass spc. but selftest is always ok
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod