Electronics > Repair

TDK-Lambda Z+

(1/1)

rtekal:
Hi
I have a TDK-Lambda Z+ 36V / 12A Power supply.  It shows fail, when the output is switched on. After swapping the control board from a borrowed good unit, and later swapping the IC A106 on the control board, the failure got resolved. It's a TSSOP with 508RP marking with ST logo. The ST website does not have any info regarding the same. No service manual is also available.
Need help on this.
Thanks for your time.
Regards


syau:
M95080-RDW6TP

https://www.st.com/resource/en/datasheet/m95080-r.pdf

rtekal:
HI

Can we copy the eeprom data to a new eeprom. I have a Z+ with a mismatch between the output and displayed voltage.  I am getting full voltage at output but the display goes upto only 2.4 v at max voltage.I replaced the eeprom from a good unit and it was ok. It is not correcting even after a factory reset.

Regards

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod