Electronics > Repair
TDS3014 adventures
lecatron07:
rauldm i tried that it doesn't boot
it stays at the update stage
sicco i tried the floppy but i will try your BDM
i may buy a FTDI4232 board and test with your software
sprit:
Hello, have a good day everyone.
I know this topic is quite old but I just encountered a problem and hope you can help.
I have a TDS3032B scope, after the DS1742W battery died, I tried to replace the CMOS battery for it and then I got this situation. The display is blank or stuck at the welcome screen. I don't know what's wrong with it...
I don't have a TDS3GM/GV card, I'm ordering the FT4232 controller board, it should arrive in a few days. But when looking at this pinout I got confused, does anyone know how to arrange their numbers? I don't know the location of pins 2,3,4,...etc, except for pin 1, which I guess is a square pinout like the picture. Can anyone help me? Thank you very much <3
Sincerely,
JingFeng
picburner:
The pinout is as per the attached pic.
sicco:
The formal pin numbering is as in the previous post.
However, the ‘budget version’ plugin board that i designed uses a different numbering convention. That’s because the budget board uses pcb edge connector instead of the https://eu.mouser.com/ProductDetail/TE-Connectivity/1-1734099-0?qs=sGAEpiMZZMvlX3nhDDO4AKFmralhIPMMK7YJ2cTxry4%3D.
PS pressing the B-Trig button while scope powers up may also reset the NVRAM to a state where boot procedure does work. But ethernet MAC address will not be restored.
sprit:
Thank you very much <3
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version