Electronics > Repair
TDS3014 adventures
<< < (32/34) > >>
sicco:
I think I spotted your wiring error.
Try wiring like this with the red edits.


Then it worked at my end with a FT2232H mini module.




Jarek:
Thank you @sicco.
Are you sure I should do this?
pin 67 is GND
Can you check it please?
sicco:
Yes.
There are lots of GND pins on the 100 pin connector. Just pick one. Maybe use a multimeter to beep through, just to be sure…
Jarek:
In your drawing (red lines), have you connected SRST to 67pin -GND  ?

I'm afraid that this ft4232h is damaged or has a bad eprom program. Do you have a file for this minimodule with Ft_PROG?
sicco:

--- Quote ---In your drawing (red lines), have you connected SRST to 67pin -GND  ?
--- End quote ---
No.


--- Quote ---I'm afraid that this ft4232h is damaged or has a bad eprom program. Do you have a file for this minimodule with Ft_PROG?
--- End quote ---
Unlikely that you damaged your FT4232H mini module, but here's the xml config file that i used in my ft2232h mini module.

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod