Electronics > Repair

TDS3014 adventures

<< < (32/34) > >>

sicco:
I think I spotted your wiring error.
Try wiring like this with the red edits.


Then it worked at my end with a FT2232H mini module.




Jarek:
Thank you @sicco.
Are you sure I should do this?
pin 67 is GND
Can you check it please?

sicco:
Yes.
There are lots of GND pins on the 100 pin connector. Just pick one. Maybe use a multimeter to beep through, just to be sure…

Jarek:
In your drawing (red lines), have you connected SRST to 67pin -GND  ?

I'm afraid that this ft4232h is damaged or has a bad eprom program. Do you have a file for this minimodule with Ft_PROG?

sicco:

--- Quote ---In your drawing (red lines), have you connected SRST to 67pin -GND  ?
--- End quote ---
No.


--- Quote ---I'm afraid that this ft4232h is damaged or has a bad eprom program. Do you have a file for this minimodule with Ft_PROG?
--- End quote ---
Unlikely that you damaged your FT4232H mini module, but here's the xml config file that i used in my ft2232h mini module.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod