Electronics > Repair
Tek TDS754c error
<< < (2/2)
44kgk1lkf6u:
There is an erase setup and ref memory option in the utility menu.
TERRA Operative:
First, you need to do a factory reset. Also check time and date is set correctly (It doesn't need to be set to right now, but must be a valid value. I've seen errors pop up when the time/date was corrupted).

Shift > Display/Utility > Tek Secure Erase Memory soft button > Ok
(You will see how to set the time here too)

Then 'Save/Recall' Setup button > Recall Factory Setup soft button > Ok


Then reboot and once warmed up perform the SPC.
If that passes ok, then run the extended self test in the Diag/Err menu, just under the Cal menu selection for the SPC.

Do you have a way to connect the scope via GPIB to your PC?
jheatac:
Thanks,

I had already did the erase procedure a few times, however I don't remember seeing an option for restoring. I'll check that shortly and try again.
jheatac:
I do not believe I have a button to save/recall setup at least that I can find.

I do not currently have any way to interface the GPIB. What would I need? a USB to GPIB adapter?
TERRA Operative:
The save/recall setup button is located second from left, on the second row down from top (not counting the buttons around the screen).
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod