Electronics > Repair
Tektronix CSA-8000 / TDS-8000 repair experiences?
<< < (10/13) > >>
GastonBA:
Hey, could you guide into what you did to have XP working?
I am suspecting that the PCI1225 is part of the problem that has conflicts on my unit (no enough resources).

Thank you,

Gaston
GastonBA:
Jose, could you help? I am stuck on XP upgrade.

Gaston
Jwalling:

--- Quote from: GastonBA on September 02, 2018, 04:52:51 am ---Hey, could you guide into what you did to have XP working?
I am suspecting that the PCI1225 is part of the problem that has conflicts on my unit (no enough resources).

Thank you,

Gaston

--- End quote ---

I think the PCI1225 MAY be the PCMCIA controller. If so, that's not a problem. Check the vendor ID in the device manager - if it's TI then don't worry about it, your problem lies elsewhere.
rizal5478:
Hi Jay, Recently happen to my unit CSA8000 which I can't enter to boot setup and keep on error show drive A & B drive error. For 1st time shall I run your corrupt.zip through floppy disk? Thanks in advance for your advise.

Jwalling:

--- Quote from: rizal5478 on April 20, 2020, 01:20:15 pm ---Hi Jay, Recently happen to my unit CSA8000 which I can't enter to boot setup and keep on error show drive A & B drive error. For 1st time shall I run your corrupt.zip through floppy disk? Thanks in advance for your advise.

--- End quote ---

Yes, that will allow you to get into the BIOS setup again. One of the most idiotic BIOS bugs I've ever seen...
You will need to connect a VGA monitor to the NLX motherboards VGA port, then set the default video from AGP to PCI in the BIOS.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod