Electronics > Repair

Tektronix CSA-8000 / TDS-8000 repair experiences?

<< < (10/13) > >>

GastonBA:
Hey, could you guide into what you did to have XP working?
I am suspecting that the PCI1225 is part of the problem that has conflicts on my unit (no enough resources).

Thank you,

Gaston

GastonBA:
Jose, could you help? I am stuck on XP upgrade.

Gaston

Jwalling:

--- Quote from: GastonBA on September 02, 2018, 04:52:51 am ---Hey, could you guide into what you did to have XP working?
I am suspecting that the PCI1225 is part of the problem that has conflicts on my unit (no enough resources).

Thank you,

Gaston

--- End quote ---

I think the PCI1225 MAY be the PCMCIA controller. If so, that's not a problem. Check the vendor ID in the device manager - if it's TI then don't worry about it, your problem lies elsewhere.

rizal5478:
Hi Jay, Recently happen to my unit CSA8000 which I can't enter to boot setup and keep on error show drive A & B drive error. For 1st time shall I run your corrupt.zip through floppy disk? Thanks in advance for your advise.

Jwalling:

--- Quote from: rizal5478 on April 20, 2020, 01:20:15 pm ---Hi Jay, Recently happen to my unit CSA8000 which I can't enter to boot setup and keep on error show drive A & B drive error. For 1st time shall I run your corrupt.zip through floppy disk? Thanks in advance for your advise.

--- End quote ---

Yes, that will allow you to get into the BIOS setup again. One of the most idiotic BIOS bugs I've ever seen...
You will need to connect a VGA monitor to the NLX motherboards VGA port, then set the default video from AGP to PCI in the BIOS.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod