Electronics > Repair
Tektronix DPO7104 repairs
<< < (5/9) > >>
pasta2018:
Thanks. I will learn it, hope I can fix my dpo7104 first
pasta2018:
It turned out that R632 was desoldered
iAleks:
Your scope work now? SPC pass?
pasta2018:
Not yet.Now the two fans are running normally.
I uninstalled the tekscope before and am now reinstalling it, not sure if the acquisition board is still faulty.
pasta2018:
Quite difficult.
When I install tekscope, it reports ddsigninstall32.exe error and then continue.

After installation, the tekscope start and then it report x08e error, then shutdown and restart.


Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod