Electronics > Repair

Tektronix DPO7104 repairs

<< < (5/9) > >>

pasta2018:
Thanks. I will learn it, hope I can fix my dpo7104 first

pasta2018:
It turned out that R632 was desoldered

iAleks:
Your scope work now? SPC pass?

pasta2018:
Not yet.Now the two fans are running normally.
I uninstalled the tekscope before and am now reinstalling it, not sure if the acquisition board is still faulty.

pasta2018:
Quite difficult.
When I install tekscope, it reports ddsigninstall32.exe error and then continue.

After installation, the tekscope start and then it report x08e error, then shutdown and restart.


Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod