Electronics > Repair
Tektronix DSA8200 repair need drivers/recovery DVD or some Tek TDS7000B,TDS6000B
(1/4) > >>
smaultre:
Hello my friends, i'm trying to install WinXP to this scope. But i need drivers for it.
I need a:  "Tektronix DSA8200 Operation System Microsoft Windows XP pro SP2b Recovery Media DVD 063-3981-00"
Or somebody with this model of scope, who can extract driver from installed OS.
Maybe some of the Tek TDS7000B,TDS6000B  (B!!!) series drivers are compatible.
coromonadalix:
free registration on xdev's may give you some iso's   or ghost images you can open with ghost explorer (v12.xxx  works, can be freely found)

on xdev's you have tds7000b folder with many iso's  and they have an  ghost of a csa 8000,  maybe some in it ?

for tds7k series  there is many drivers, front panel, power  Pc   etc ...     motherboard ?

on tek w free registration :
https://www.tek.com/en/support/software/application/8000-series-oscilloscope-firmware-windows-xp-v5213


do you have this one ?


and maybe some directions here : https://www.eevblog.com/forum/repair/tektronix-csa-8000-tds-8000-repair-experiences/
coromonadalix:
here's the ones i have for a csa8000  backup

https://filebin.net/801x76a4c3eu8yza           dies in 6 days from now,  EDIT  they are kinda a drag to download ...  i may change the hosting


and pls  don't double thread .....   i see you posted at places here, sure you need help ...   

you have TEK forums too   ... but silent on some of your problems    good luck
smaultre:
Hello, Thank you for helping!
Now i have DSA8200 platform with p4 (s775) motherboard, that model runs XP or upper OS..
It have a PCI type inter-connector board between WIN MoBo and vxWorks MoBo PC's.
It doesn't support win2000 or win98 drivers for 8000 platform.
It has it own's types of vxWorks OS and config files, not comparable with old 8000, 7000 platform.
coromonadalix:
the 7000B  series has some interlink pcb between the mobo and the scope power pc

normally  you need to answer all the pc side drivers errors   before even trying to start the scope side

and to help,   you list  all the  vid's pid's of each hardware from the device manager,  it help finding drivers,  but the 1st driver for sure is the Intel INF driver

for vxworks  you need to connect to any console port if there is one ? and see if it ticks okay, any errors there too will not start the scope software


xp in some cases  can accept older os drivers

alas  you have one guy on Ebay who claim to sell an compiled tek drivers & os'es recovery  disk,  but very pricey,  not sure your model is there ...
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod