Electronics > Repair
tektronix TDS 3034B
(1/1)
hitecelec:

hello

How does one clean the rotary encoders/switches of the scope
Volts/div, Time/div etc

Thanks in advance
sicco:
Many hints here: https://www.eevblog.com/forum/repair/tds3000b-tds3054b-strange-type-rotary-encoder-repairreplacement/msg2825664/#msg2825664

and

https://www.eevblog.com/forum/testgear/tds3000b-tds3054b-rotary-encoder-repairreplacement/msg3578292/#msg3578292

coromonadalix:
i would have used a small twist drill   make 2 small holes,  1 near each plastic post who pass thru the pcb 

on the other linked thread you see how the pcb pads are ...  just drill location when the circular pads are not under the square frame

i  first would not decap theses from the pcb,  but try cleanup before anything else
hitecelec:

hello

thanks for all the inputs
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod