Electronics > Repair
Tektronix TDS5054B: Record Length Option: Solved!
<< < (5/16) > >>
Ko:
Thank you, Mr Calibrationfixture.
I have same issue to TDS6154C.

Do you know how to generate the correct code for this oscilloscope?
calibrationfixture:
Hi Ko,

No problem to generate a Key for this Instrument. I assume you know how to use the gen.py Program. On this moment I am looking for the Recovery Disk(s) for the TDS6000B/C Series or an image of its HDD.

Calibrationfixture
Ko:
I checked if gen.py can generate the valid code, however generated code can’t be used.
Of course I know how to use gen.py and validate as I have used it with 5034 and 7404 to get valid code.
For 6154 I tried to generate code by adding “00…” or some kind of changes but failed so far.
Can you advise me?
calibrationfixture:
Hi again,

For a TDS6154C you must use TDS6154B and for a TDS6124C you must use TDS6124B as Model. That's all.

Greetings,

Calibrationfixture
Ko:
I know the relations.
However the generated code is not accepted with the scope.
I think the cause is for the incorrect length of option mask or similar problem which I have experienced for TDS5034B.

Do you have any examples of option code for TDS6254C?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod