Electronics > Repair

Tektronix TDS5054B: Record Length Option: Solved!

<< < (5/16) > >>

Ko:
Thank you, Mr Calibrationfixture.
I have same issue to TDS6154C.

Do you know how to generate the correct code for this oscilloscope?

calibrationfixture:
Hi Ko,

No problem to generate a Key for this Instrument. I assume you know how to use the gen.py Program. On this moment I am looking for the Recovery Disk(s) for the TDS6000B/C Series or an image of its HDD.

Calibrationfixture

Ko:
I checked if gen.py can generate the valid code, however generated code can’t be used.
Of course I know how to use gen.py and validate as I have used it with 5034 and 7404 to get valid code.
For 6154 I tried to generate code by adding “00…” or some kind of changes but failed so far.
Can you advise me?

calibrationfixture:
Hi again,

For a TDS6154C you must use TDS6154B and for a TDS6124C you must use TDS6124B as Model. That's all.

Greetings,

Calibrationfixture

Ko:
I know the relations.
However the generated code is not accepted with the scope.
I think the cause is for the incorrect length of option mask or similar problem which I have experienced for TDS5034B.

Do you have any examples of option code for TDS6254C?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod