Electronics > Repair
Tektronix TDS5054B: Record Length Option: Solved!
nicnac117:
Hi again .........
I tried all keys for the VM5000 you sent and they all work for all the application /options I have installed from the disc available . They all keep the VM5000HD&SDVideo and the 3M 16 meg enabled so all good .
The first one with 14f s works and stops at 70 available
the 28fs stops at 127apps available not installed
the 30fs stops at 135apps available not installed .
So It would appear that the 14fs takes in all apps up to 70 which includes the last live app i have at entry 69 "Protocol trigger and decode".
I can tabulate all the entries for each key if that is helpful .
for those with the TDS5104 non B most of this can be enabled including the VM5000 software available as a trial of 5 goes on tek website . Once you have enabled key and the 5 goes run out the next time it starts ok with no trial warning .
charlyd:
Did anyone here restore a TDS7000 windows XP image onto a TDS5000 unit and then uninstall the tekscope software and install the correct version. and see what happened?
of course tweaking is needed. i ll come back on this one later in the future
colorburst:
Charlyd, there is no point, aside from the front panel, the drivers are completely different. Might as well start with a clean XP install.
I've done this before and it works. I found it pointless too because the Pentium III lacks SSE2 and much of the newer software doesn't work anyway. If you upgrade the motherboard or do this on a B scope, it might make more sense. Additionally, XP is believed to have some issues with the GPIB driver but I haven't tested that.
Bravo:
Hi All,
Can anyone confirm that the PSU & the 2 fans on the left all blow inwards.
colorburst:
It's the other way, all three fans blow air out of the instrument.
Fresh air is drawn in through the bottom vents where it cools the acquisition board.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version