Electronics > Repair
Tektronix TDS784C HDD
<< < (3/3)
TERRA Operative:

--- Quote from: G10mar3xp10r3r on November 20, 2021, 06:18:51 am ---Hi TDS HDD users.. This is an interesting thread as I was the original designer of the TDS's HDD option.   This option evolved quite a bit from PCMCIA into second generation 2.5" PATA drives.   Did you know you can insert a NE2000 PCMCIA network card into your instruments PCMCIA slot and  get a full network stack?   I've been contemplating writing up some of of the stupid TDS500/600/700 tricks but have no idea if there are enough folks out here that have any residual interest in these instruments.    I've been contemplating building a contemporary storage/nic card as a replacement to the original HDD option card.    I wonder how many interested users would be interested in this?

Regards

--- End quote ---

I am so interested it hurts! :D

Please teach us your knowledge!


Also, I'm on the hunt for a HDD option for my TDS784C too.
Wallace Gasiewicz:
I do not know if this is of any help but here goes:
I purchased an Agilent 54810 scope from someone on this blog. The seller had installed a SSD Drive. I think the original HDs on this unit were none too good.
The SSD is partitioned to be of an acceptable size for the CPU. The thing works just fine.
EduardGede:
Hi,...

is this still alive !!!!

Sounds good.
TERRA Operative:
Do you have a HDD option in your scope?
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod