« previous next »
Pages: [1]   Go Down

Author Topic: Tektronix WFM601i Calibration Software?  (Read 535 times)

0 Members and 1 Guest are viewing this topic.

Offline TEKhackerTopic starter

  • Newbie
  • Posts: 6
  • Country: gb
Tektronix WFM601i Calibration Software?
« on: October 30, 2023, 10:31:42 am »
I am looking for a source of the Calibration Software (cal.exe & .prc files) for a Tektronix WFM601i waveform monitor.
I have the Cal.exe for the WFM601A, E, M series but it does not work with the 601i model.
Thanks
Logged
 

Offline Swake

  • Frequent Contributor
  • **
  • Posts: 588
  • Country: be
Re: Tektronix WFM601i Calibration Software?
« Reply #1 on: November 01, 2023, 06:12:19 pm »
On the Tek site apparently:

Where can I get the WFM601i calibration software?
https://www.tek.com/en/support/faqs/where-can-i-get-wfm601i-calibration-software
Logged
When it fits stop using the hammer
 
The following users thanked this post: TEKhacker

Online coromonadalix

  • Super Contributor
  • ***
  • Posts: 6851
  • Country: ca
Re: Tektronix WFM601i Calibration Software?
« Reply #2 on: November 02, 2023, 12:14:24 am »
this is a dud    there is no download link
Logged
 
The following users thanked this post: TEKhacker
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee