Electronics > Repair
test transformer that has modular connectors with small holes
(1/2) > >>
smk279:
the holes are smaller than my test leads and on the other side where wire enters the modular connector I can't see metal I have no idea if my leads are making any contact To find if the transformers not working can I just use a clamp meter to see if there's any dc voltage coming out of it
Roehrenonkel:
Hi,
 
...if it's a tranformer than i'm sure it's not outputting any DC.
Even without PICTURE. ;-)
smk279:
Here's a pic So you're saying there's only ac coming from the transformer
Roehrenonkel:
Hi,
 
still can't see the connector in question.
You could try stick a resistor or other small wire into it.
Checked the main-fuse, voltage-selector and power-switch?

Good luck
CaptDon:
Those are not connectors on the transformer. You have made two wrong assumptions so far, maybe let a qualified person have a look at the unit.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod