EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: patolog1964 on October 03, 2021, 09:45:19 am

Title: TL866 II Plus Self-Check Error
Post by: patolog1964 on October 03, 2021, 09:45:19 am

I have got a XGEcu Minipro TL866II Plus programmer with the latest software and firmware from XGecu website. It was working perfectly but couple of days ago, I started experiencing problems with the programmer. It showed messages of IC short circuit / over-current messages. When I did self-check from the test menu, I found an Error called "VCC ERROR:. I have attached the screenshot for the same. I need help to fix the issue.Can someone explain me how can i possibly repair this or am i scre*ed? :)
Should i check some pinout traces if its HW problem or is problem with SW? :)
Iˇve tried switching OS to 32 bit,no issue.¨
Thanks for any advice,would be grateful for any tips.

Iˇve uploaded screenshot of that error down below.

Title: Re: TL866 II Plus Self-Check Error
Post by: drakepirate on March 08, 2023, 05:00:08 am

Got similar Error on my TL866II+. :-BROKE
Let me know if you solved it Please...
Thanks.

Title: Re: TL866 II Plus Self-Check Error
Post by: Yhoni on April 03, 2023, 11:06:43 pm

Hello friends, I have the same problem.

Anyone could fix it??

Could you share it, please?

Title: Re: TL866 II Plus Self-Check Error
Post by: m k on April 08, 2023, 02:19:50 pm

Go back to earlier firmware and try USB port where it has never been.