TL866CS/RT809H

[lionelkjh]

Hello; to program: MK-328; TS-M8N, LCR-T4; can you use a programmer like: TL866CS and RT809H with a suitable support (TQFP32) for an ATMEGA 168/328 microprocessor ?? If so, is there 2 software to enter? Thanks for your help!

[giacomo]

MK-328; TS-M8N, LCR-T4 are those component testers, right ?

Yes you can, i had to replace the atmega 328 micro in my bside esr02 and i used the tl866cs

The program for the tl866cs is xgpro and you can download it from the official website, there are also alternative for linux

[coromonadalix]

for both the programmers you can check a list of all the ic's they can do

tl866 : http://autoelectric.cn/minipro/MiniProSupportList.txt

rt809:  https://kphstore.com/rt-809h

[BrokenYugo]

Probably easier to use the ICSP header that those testers usually have a spot for on the board if the AVR isn't a socketed DIP package.

[lionelkjh]

Hello; yes, but you have to send 2 files to the microprocessor; however, we can only make a transfer from the TL866CS or the RT809H using the appropriate medium! Should you therefore use the RT809H using an ISP connector directly on the tester board to program it? I don't have a diagram for the 3 testers ?? Can someone help me??

[lionelkjh]

HELP ME!

[lionelkjh]

 

[coromonadalix]

I have a hard time to understand you

Vous etes dur a comprendre dans votre enonciation, vous etes francais ??


If the boards have an icsp connector you can program them on the board, if not, you have to remove the ic and put them in the programmer, if it need a ic socket  you have to get one and put the ic in it.

You need to know the ic  "fuses" configurations ...   or try to read them before erasing the chip and program it / update it ?.


Search google for theses testers schematics exists or do them yourself ??  you have a big thread here for an avr component tester ...
https://www.eevblog.com/forum/testgear/$20-lcr-esr-transistor-checker-project/

[lionelkjh]

Hello; what I wanted to say is how to program it with the TL866 or the RT809H, because with the 2 available software it does not work anymore! ?? All the testers turn on and off without functioning because they have not been reprogrammed ?? A mystery reigns over these 2 boxes ..... Thanks for your help!

[PKTKS]

I am not sure... but if I understand you right...

You should go AVRDUDE http://www.nongnu.org/avrdude/

which is de facto the tools used on all AVR across multiple OS.

Always work when properly mastered..

Paul