Hey folks, so the display on my toolkit M7 cracked. It's about 1.8" wide and has 10 connectors on the ribbon cable. Toolkit are ignoring my ticket for a replacement so screw them!
Is it likely I could get a similar display to work? Suspect it is TFT give the crack and visible liquid, just not sure what the pin config is but surely can't be custom? Connector goes straight to a micro so must be some standard interface such as SPI or i2C I'd think...
I should try probing the outputs but not got the room on bench atm...
Pics below...
https://photos.app.goo.gl/3opZ5tRrQfgd73aA8https://photos.app.goo.gl/9xjDwvbqGwh45CfB6