Electronics > Repair
TTi EX355P Power Supply - Current Limit problem
(1/1)
alfredo80:
Hi to all the electronics passionates that will read this post.
My TTi EX355P Power supply has a strange problem : when I try to set the current limit, I start to rotate the current knob and I see the value increments on the display. Then, at 2 Amps it stops. The Power Suplly is rated 5 Amps and I can't understand why I can't reach the full rating.
I can't find the schematics online. I've found the EX354D service manual, but it has the analog potentiometers instead of encoders for current and voltage adjustment. In fact, I can see two TC516 DACs on my controller board that are not present on the EX354D schematics. They are used to set the references for the voltage and current loops, I gues.
Any ideas for troubleshooting? I see there is a PIC microcontroller on the board. I hope it's not faulty because I don't have the Software to load into it.
Thanks in advance to all,
Alfredo
Harry_22:
Hi Alfredo!

Try to reduce output voltage. May be the output power is limited.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod