Author Topic: TTi PL320T-GP Service Manual or How to Remove GPIB board to allow PSU's to run.  (Read 965 times)

0 Members and 1 Guest are viewing this topic.

Offline navzptc

  • Contributor
  • Posts: 26
I have just purchased in very nice condition 2 x PL320 psu's coupled up to a PL320T-GP GPIB unit.

I do not require the GPIB unit and planned to remove it and just run the psu's on their own, but on disconnecting the cables from the GPIB unit (and leaving in local mode) I get an error message being shown on both voltage readouts  :(

There must be a way to run these on their own, and presume it will just be a case of making a few more links on the psu units to work.

Any suggestions or relevant service manuals would be most appreciated.

Andy
 

Offline macboy

  • Super Contributor
  • ***
  • Posts: 2011
  • Country: ca
I know from experience that if you write TTi and ask nicely, they will almost certainly send the user and service manuals to you.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf