| Electronics > Repair |
| Unified tektool released ! (Firmware flash tools for old Tektronix TDS series) |
| << < (23/24) > >> |
| keystone:
--- Quote from: TERRA Operative on July 17, 2023, 07:50:22 pm ---Completely uninstall all GPIB software and then just install the Keysight IO Suite. You might have conflicts with the VISA drivers from different companies. There's no way to know what is going on with your setup unless we begin from a clean start. --- End quote --- I tried, followed your instructions that you posted earlier and it didn't work for me. I will remove all keysight and NI software and just reinstall keysight and see what happens. Thanks. |
| keystone:
--- Quote from: keystone on July 17, 2023, 09:32:21 pm --- --- Quote from: TERRA Operative on July 17, 2023, 07:50:22 pm ---Completely uninstall all GPIB software and then just install the Keysight IO Suite. You might have conflicts with the VISA drivers from different companies. There's no way to know what is going on with your setup unless we begin from a clean start. --- End quote --- I tried, followed your instructions that you posted earlier and it didn't work for me. I will remove all keysight and NI software and just reinstall keysight and see what happens. Thanks. --- End quote --- Update: I got my agilent 82357B USB-Gpib adapter working with my windows 10 computer and TDS640A. Yey! When I tried to get my flash ID I got failed. Don't know why. I uninstalled the Keysight and NI stuff and tried to reinstall only keysight IO suite but it said I still had some other company's software on computer so I intalled it anyway and told it to be primary and that worked. I guess the keysight IO suite was installed as secondary Visa at first. Now, question as to what to type in for the nvram contents for my tds620A, 640A, and 644a scopes? Would they all be the same addresses and lengths? Can someone tell me what to use for these entries? Thank you. I'm making progress! |
| leonpav:
Hello Tek scope folks! My Tek794D is getting old, and I just wanted to report that I've successfully saved the NVRAM by the instructions from the first post here :) I have the NI USB-HS adapter. Seems the Tektool was happy with my Win7+NI drivers and it reported: "0x89a0 = 28F016SA". Now I must save the FW as well... Big thanks to all the developers here!!! :DDD |
| 3g57:
--- Quote from: leonpav on April 11, 2024, 08:23:40 pm ---Hello Tek scope folks! --- End quote --- Good day! leonpav Question: Can you share your firmware files TDS794D |
| CaptDon:
Shonky, I have a good working TDS644B. It has the newer better Acquisition board unlike the TDS644A that I sold. Can you tell me specifically, or with a picture of the ACQ board what jumpers you removed and any other mods or software changes required. Do I understand there are jumpers to be removed as well as some bandwidth limiting capacitors at each of the 4 ADC I.C.'s? I have already installed the aftermarket NVRAM conversion I.C.'s which I purchased on Ebay. They are working fantastic for me and glad to have them. Thank-you for your help!!! |
| Navigation |
| Message Index |
| Next page |
| Previous page |