Electronics > Repair
Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)
<< < (24/24)
Tantratron:

--- Quote from: 3g57 on January 06, 2025, 03:48:25 pm ---
--- Quote from: leonpav on April 11, 2024, 08:23:40 pm ---Hello Tek scope folks!
--- End quote ---


Good day! leonpav
Question: Can you share your firmware files TDS794D

--- End quote ---
Hello, just out of curiosity, why do you need firmware for your TDS794D ?
The pictures you have shown are from your TDS794D ?
If yes, how about you use USB-GPIB to copy the 3 files (firmware, EEPROM calibration and NVRAMs) ?
Mgelderland:
Hoi
I can confirm that it is possible to convert a TDS744 (Non A) to a TDS784A. and from firmware v1.0e to v4.2.1e. the first time it didn't work and I had a mismatch with firmware verification. that probably had to do with the fact that the firmware erase did not go well right away and had a few retries. I continued to repeat the firmware removal process until everything was 100% removed at once without retries. then load and check the new firmware. I did everything with the tektool. and the correct order was followed. Please note that a full calibration is required due to firmware upgrade and bandwidth.everything of course at your own risk.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod