Electronics > Repair

Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)

<< < (24/24)

Tantratron:

--- Quote from: 3g57 on January 06, 2025, 03:48:25 pm ---
--- Quote from: leonpav on April 11, 2024, 08:23:40 pm ---Hello Tek scope folks!
--- End quote ---


Good day! leonpav
Question: Can you share your firmware files TDS794D

--- End quote ---
Hello, just out of curiosity, why do you need firmware for your TDS794D ?
The pictures you have shown are from your TDS794D ?
If yes, how about you use USB-GPIB to copy the 3 files (firmware, EEPROM calibration and NVRAMs) ?

Mgelderland:
Hoi
I can confirm that it is possible to convert a TDS744 (Non A) to a TDS784A. and from firmware v1.0e to v4.2.1e. the first time it didn't work and I had a mismatch with firmware verification. that probably had to do with the fact that the firmware erase did not go well right away and had a few retries. I continued to repeat the firmware removal process until everything was 100% removed at once without retries. then load and check the new firmware. I did everything with the tektool. and the correct order was followed. Please note that a full calibration is required due to firmware upgrade and bandwidth.everything of course at your own risk.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod