Electronics > Repair
Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)
<< < (5/24) > >>
james_s:
Is it possible to get this to support the Prologix USB GPIB adapters? Due to some clones that have been developed Prologix is rapidly becoming the defacto standard, at least for hobbyists.
madao:
If you give me  source file for prologix GPIB controller, then is it possible.

Or: can you try  with  this tektool ?  (This tektool run with agilent & NI controller)

@lucatz

yes , it is in most case possible: upgrade without losing of calibration data, because most firmware use same calibration data schema.
If it is failed, you can going back to  old  firmware.
james_s:
The thread is here: https://www.eevblog.com/forum/projects/ar488-arduino-based-gpib-adapter/

It enumerates as a USB serial port and uses mostly standard GPIB commands.
SergeyMinin:
Hey. My TDS 654C oscilloscope has firmware version v5.1e. Does anyone have a newer firmware version for the TDS 654C? And please tell me is it true that version v5.2e from TDS 784C is suitable for my oscilloscope?

Sergey
madao:
No,   TDS500/700 and TDS600 is extremely difference by  acquisition board.   You can put newest TDS500 Firmware to TDS700, if  suffix is same.  But never to  TDS600.  Same  with TDS600 firmware at  500/700 units.  Difference  between 500/700 is minor by software. (no colour display, it is all !)

A luck, you have asked me :-)

Greetings
matt
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod