| Electronics > Repair |
| Unified tektool released ! (Firmware flash tools for old Tektronix TDS series) |
| << < (6/24) > >> |
| madao:
--- Quote from: james_s on November 28, 2020, 09:50:50 pm ---The thread is here: https://www.eevblog.com/forum/projects/ar488-arduino-based-gpib-adapter/ It enumerates as a USB serial port and uses mostly standard GPIB commands. --- End quote --- Oh, it look good, but i must take time for him. (actually , i have less time :-/ ) |
| vaualbus:
Were you find those firmware list? I'm looking if possible to update my TDS firmware to newer mine is 2.13 I see there a 2.16e. You think is that possible? I guess there has not diffs between the version? |
| hgross:
Hello Matt (madao), Thank you very much for your tektool. Together with Ghidra it opens new possibilities for me to understand and hopefully repair old TDSxxx Scopes. I was able to repair a TDS644A and it seems to work 100 % o.k. but the self test fails due to the digACCalDiag test. The built-in frequency test range seems to be set too narrow. Either my firmware (3.8.5e), which I have copied from KO4BB is not good for my TDS644A or something in the file is corrupt. Could anyone in this forum provide a similar or even newer firmware for the TDS6xxA series? Regards Helmut, DL5HG |
| vaualbus:
We shall reverse engineer the firmware yeah, apparently reading the extended service manual I got for the TDS540A they had a tool that described and allow to execute any of the diagnostics procedures tha the TDS520 repair manual suggest to run. I guess there is ay to write such a a program our self and finally allow to simplify the repairs of these scopes. |
| vaualbus:
Can you provide the tools for Win98/95 so we can use with the official card suggest in the manuals that is the ISA National GPIB-PCII/IIA Card? |
| Navigation |
| Message Index |
| Next page |
| Previous page |