Electronics > Repair
Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)
drforbin:
I'd like source code if possible
eurgenca:
Hello, Matt.
I have a faulty tds420a and I want to play with your software. I don't have GPIB adapter and need to buy one.
Does this sw work with USB to GPIB adapters or I must find some ISA/PCI card?
Thanks, Sebastijan.
madao:
100% confirm: it works with NI GPIB Adapter, USB or PCI or PCIe, is not important. Important is NI 488.2
(not 100% confirm, work with agilent GPIB-USB Adapter, doze people told me, it works)
eurgenca:
Hello.
So this chinese clone will be o.k.?
https://www.aliexpress.com/item/1005002298355146.html?spm=a2g0s.8937460.0.0.67972e0e7Yk0v5
Sebastijan.
Tantratron:
--- Quote from: eurgenca on September 18, 2021, 01:00:14 pm ---Hello.
So this chinese clone will be o.k.?
https://www.aliexpress.com/item/1005002298355146.html?spm=a2g0s.8937460.0.0.67972e0e7Yk0v5
Sebastijan.
--- End quote ---
If I were you, best to buy a used NI-GPIB-USB (made in Hungary) where for sure it works including with Macintosh.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version