| Electronics > Repair |
| Unified tektool released ! (Firmware flash tools for old Tektronix TDS series) |
| << < (13/24) > >> |
| TERRA Operative:
--- Quote from: Ross2 on February 25, 2022, 09:09:37 am ---I just ordered the Keysight 82357b. I'm not sure it that's the issue, It could be something that I am doing wrong. I can not turn off the "Off Bus" setting on the GBIP settings on ether scope. I tried it on a TDS640a and a TDS754c that was upgraded to a TDA784c. It's under Utility - System Config - IO - GPIB. --- End quote --- I don't change any GPIB settings in the scope after a factory reset and the connection works fine, tested with 7 different scopes now. Once you get the Keysight GPIB adapter, you should be able to connect. I just got the HDD option for my scope installed, but minimum firmware required seems to be 5.3 (I have 5.2) so I'm waiting with bated breath to get a copy of your firmware now. :D |
| madao:
yes, pleas save this firmware :-) unified Tektool (same as orginal tekfwtool & tektool) requiered (NI) VISA Interface. But few people told it already. |
| Tantratron:
P.S. You might check this repository https://github.com/ragges/tektools |
| Tantratron:
--- Quote from: Ross2 on February 25, 2022, 06:44:06 am ---I have V5.3e but I have been having a problem getting connected to the gbic port with a usb to gbic. (Attachment Link) --- End quote --- It would be great to have a copy of 5.3e firmware, thank you |
| TERRA Operative:
Just a bump as a reminder to Ross2 to copy out that 5.3e firmware. :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |