Electronics > Repair

Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)

<< < (13/24) > >>

TERRA Operative:

--- Quote from: Ross2 on February 25, 2022, 09:09:37 am ---I just ordered the Keysight 82357b. I'm not sure it that's the issue, It could be something that I am doing wrong. I can not turn off the "Off Bus" setting on the GBIP settings on ether scope. I tried it on a TDS640a and a TDS754c that was upgraded to a TDA784c. It's under Utility - System Config - IO - GPIB.

--- End quote ---

I don't change any GPIB settings in the scope after a factory reset and the connection works fine, tested with 7 different scopes now. Once you get the Keysight GPIB adapter, you should be able to connect.

I just got the HDD option for my scope installed, but minimum firmware required seems to be 5.3 (I have 5.2) so I'm waiting with bated breath to get a copy of your firmware now. :D

madao:
yes, pleas save this firmware :-)

unified Tektool (same as orginal tekfwtool & tektool) requiered (NI) VISA Interface. But few people told it already.

Tantratron:
P.S. You might check this repository https://github.com/ragges/tektools

Tantratron:

--- Quote from: Ross2 on February 25, 2022, 06:44:06 am ---I have V5.3e but I have been having a problem getting connected to the gbic port with a usb to gbic.
(Attachment Link)

--- End quote ---
It would be great to have a copy of 5.3e firmware, thank you

TERRA Operative:
Just a bump as a reminder to Ross2 to copy out that 5.3e firmware. :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod