Electronics > Repair
Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)
<< < (16/24) > >>
TERRA Operative:
I just upgraded my TDS784C to 5.3e, and it worked fine. Awesome! Big thanks to NathanFulton! :-+  ;D
picburner:
Me too have successfully updated my TDS784C to v5.3e.
Time taken 1132 seconds with an NI pcmcia card and 28f016sa flash memory.
calmissile:
Could someone please post or email me a compiled version of TekTool or TekFWtool for DOS or WIN98.
I am using a NI PCII/IIA GPIB board that works fine.

Doug  W6GOT
calmissile@gmail.com
madao:
Hi calmissle

Excuse me, i wouldn't compile software for old  PCII/IIA card, because.
I must installed compiler for MS-DOS and searching  source file for this card.
But i want check, does work it with Win XP and Win9x and NI 488.2 software?

My software ability is low.
DC1MC:
The one from here doesn't work ?

https://github.com/fenugrec/tekfwtool

I have a wonderful Virtual Box with Borland C++ 3.1 that I can make available to @madao or compile it myself as long as you have the card drivers and library.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod