Electronics > Repair

Unified tektool released ! (Firmware flash tools for old Tektronix TDS series)

<< < (16/24) > >>

TERRA Operative:
I just upgraded my TDS784C to 5.3e, and it worked fine. Awesome! Big thanks to NathanFulton! :-+  ;D

picburner:
Me too have successfully updated my TDS784C to v5.3e.
Time taken 1132 seconds with an NI pcmcia card and 28f016sa flash memory.

calmissile:
Could someone please post or email me a compiled version of TekTool or TekFWtool for DOS or WIN98.
I am using a NI PCII/IIA GPIB board that works fine.

Doug  W6GOT
calmissile@gmail.com

madao:
Hi calmissle

Excuse me, i wouldn't compile software for old  PCII/IIA card, because.
I must installed compiler for MS-DOS and searching  source file for this card.
But i want check, does work it with Win XP and Win9x and NI 488.2 software?

My software ability is low.

DC1MC:
The one from here doesn't work ?

https://github.com/fenugrec/tekfwtool

I have a wonderful Virtual Box with Borland C++ 3.1 that I can make available to @madao or compile it myself as long as you have the card drivers and library.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod