Author Topic: Vane VP-950 Dynometer  (Read 303 times)

0 Members and 1 Guest are viewing this topic.

Offline dalford1987

  • Newbie
  • Posts: 3
  • Country: au
Vane VP-950 Dynometer
« on: April 13, 2021, 10:57:09 am »
Hi All,

First post, long shot but does anyone have technical information or know about the Vane VP-950 chassis dynometer. I'm currently repairing one, I have repaired the control PCB before and had some success. I believe I'm getting voltage spikes from the retarder brake on the control PCB many TTL IC's failed. I'm willing to pay for service information, it would make my life easier.

Regards,


David Alford
 

Offline trobbins

  • Frequent Contributor
  • **
  • Posts: 406
  • Country: au
Re: Vane VP-950 Dynometer
« Reply #1 on: April 13, 2021, 12:28:38 pm »
I couldn't get any VANE related technical docs for a VP708 or 7100 - had to reverse engineer all the wiring and pcbs.  The operating manual is likely all you can hope for.
 

Offline dalford1987

  • Newbie
  • Posts: 3
  • Country: au
Re: Vane VP-950 Dynometer
« Reply #2 on: April 14, 2021, 03:30:17 am »
Hi,
Thanks for reply, yeah I've done a bit of reverse engineering on it. I suspect I might have a wiring issue (rubbed through) somewhere but as its intermittent I was hoping for a circuit/miracle, bit short on them currently 😀
 

Offline crerus75

  • Contributor
  • Posts: 10
  • Country: us
Re: Vane VP-950 Dynometer
« Reply #3 on: April 14, 2021, 04:37:10 pm »
I thought Mainline Dyno inherited the Vane product line years ago and were providing limited support.  Have you tried contacting them?
 

Offline dalford1987

  • Newbie
  • Posts: 3
  • Country: au
Re: Vane VP-950 Dynometer
« Reply #4 on: April 17, 2021, 07:55:30 am »
Yes I've contacted mainline but they told me they have no information etc. on the VANE stuff anymore
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf