Electronics > Repair
[FIXED] Venerable AIM TTI PL303QMD-P needs help - Overvoltage trip error
<< < (4/11) > >>
Zucca:
Okay, the problem is in one the digital PIC board (originally master).
Swapped the two and the error follows the PIC board, the other side was fixed.

Two corrections from before:
1) the misaligned molex (on the master power board) does not play a role... it is correct in both position misaligned or not..
2) the two power boards are identical but there is a hard jumper in the master (LK1)... so for basic tests you can swap them temporarily but them put them back in place.

getting closer!
Zucca:
Sorry for the delay, I am selling some stuff (go to the buy/sell section to check it out) and my 2015 Ford F150 needed some immediate attention.

Will resume this adventure soon, I am confident I will fix it.
Zucca:
uP board has some digital and analog stuff.

As a quick check the analog parts looks good.
Next I will check the DAC and ADC with a scope.

Can't be the uP because the display "Output trip" is sent by the uP iself.
Gertjan:
Hi Zucca, good to hear that you are still at it!  :-+
This very nice power supply needs to be in use on your bench, instead of sitting in your repair que  :)
m k:
On the bench already.

MCU can have separated on/off info pins for both channels.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod