Electronics > Repair
[FIXED] Venerable AIM TTI PL303QMD-P needs help - Overvoltage trip error
<< < (9/11) > >>
Zucca:
Here we go... here what I could sniff on the SPI on the GOOD working board:

Sent:
12 02 00 00 00
Received:
00 00 80 00 01

the above repeats a lot

Sporadically I get

Sent:
51 00 38
OR Sent:
51 00 58
Sent:
51 00 48
OR Sent:
51 00 28

always Received:
FF FF FF


followed by

Sent:
01 FF FF FF FF
here I get multiple possible responses

Received A:
FF 00 00 25
Received B:
00 00 15 C1

and so on, attached the sniffed traffic in .csv files.

Now dive into the ADC IC07 ADS1241 datasheet to understand what it is going on.

cool.

m k:
02 after 12 is a counter, same with 00 after 51.

FF can be a waiting thingy, but after 01 (read data) should be only 24 bits.
So last received is a byte too long, maybe it's just a hiccup.
Zucca:
sniffed the SPI from the bad uC board...



There are a lot more FF FF spitted out from the ADC to the uC.

Since I measured the inputs, and they are okay... I think the next reasonable step is to swap the two ADCs from the two good/bad board and see what happens.

Such a unicorn failure...

PS: the Picoscope for decoding serial is such a champion.
Zucca:
New ADS1241E/1K‎ ordered, finger crossed.
m k:
So single ended input channel 3 and differential 6-7 are open or pulled up.

Channel 5 is sending 32 bits, maybe nothing, but it's also positive once.
Did you check those inputs with a scope?

But anyway, ADC change is pretty affirmative thing.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod