Electronics > Repair

Vintage/Classic Chassis/Mechanical Renovation/Restoration Techniques

<< < (22/24) > >>

manicdoc:
Got a TDS540 with 3 feet, so needed another one... found this

https://www.printables.com/model/22192-replacement-feetpads-for-tektronix-tds-500600700-s/files

Covers series 500/600/700

tautech:

--- Quote from: manicdoc on August 25, 2022, 11:10:35 pm ---Got a TDS540 with 3 feet, so needed another one... found this

https://www.printables.com/model/22192-replacement-feetpads-for-tektronix-tds-500600700-s/files

Covers series 500/600/700

--- End quote ---
There is also this useful thread in the TE board with a # of Tek listings one of which has the 5,6,700 feet.
https://www.eevblog.com/forum/testgear/replacement-knobs-feet-and-fittings-for-test-equipment/

technogreek:
Hi- Need some help identifying the manufacturer (or possible successor) of this type PCB board to cable connector.  Only marking is "OTP" .  These are from approx 30-40 year old boards made in Japan.  Other components all look to be Japenese manfacturers.  Thanks

VK5RC:
@technogreek what is the pin spacing - and approx pin diameter, is the socket expecting a square, rectangular or round pin? From the photo it looks like a 0.1" pin sockets - but hard to guess.

technogreek:
as close as I can measure-- 2.5mm (0.1") pitch, square pins maybe 0.6mm(0.024") looks like a spring type latch, meaning it snaps into an opening in the socket
thanks for responding.  these old connectors are difficult!

Navigation

[0] Message Index

[#] Next page

[*] Previous page