Electronics > Repair
Weller WD1 Discussion and Repair
M. András:
if its enough proof for you
nanofrog:
--- Quote from: M. András on March 31, 2013, 08:07:00 pm ---if its enough proof for you
--- End quote ---
Wonder what's up with this?
I say this, as I double checked with Apex's site (Weller) prior to posting, which states that the WRMP = 24V.
Source: http://www.apexhandtools.com/brands/CF_Files/model_detail.cfm?upc=037103209047. Same info is duplicated in their brochure (click the literature link).
WTH Weller? :-//
M. András:
it had a dedicated station and a vertical stand and these are obsolote now that version was 24v
http://www.weller.de/products/product.php?pid=52
nanofrog:
--- Quote from: M. András on March 31, 2013, 08:29:14 pm ---it had a dedicated station and a vertical stand and these are obsolote now that version was 24v
http://www.weller.de/products/product.php?pid=52
--- End quote ---
I knew they changed the stand, but hadn't heard or seen a change to the iron or station.
Wonder why they haven't updated the US site? Perhaps the older 24V version is still being sold here (find it odd from a systems/manufacturing POV since their owners are all about cutting costs, but possible)? :-//
M. András:
it was the wrms kit what used the 24v version of this, i dont know if the wxmp different or not but i dont know the reason too why its not supported by the wd series only the wx stations
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version