| Electronics > Repair |
| Weller WD1 Discussion and Repair |
| << < (5/17) > >> |
| nanofrog:
Pics can be had too, in the following thread: https://www.eevblog.com/forum/reviews/weller-wmd-3-repair/msg210603/#msg210603 Please note however, that the boards posted by myself and another member (Baliszoft) are different from one another, so there's at least 2 PCB revisions for that model. Specifically, it's the BTA12 that is one of the parts that has a slightly different location. So you may need to trace out your particular board. Hope this helps. :) |
| nanofrog:
Here's the schematics for the WD1... |
| dungad:
Hi nanofrog, Thank you for the additional information, my WD1 unit is like Baliszoft's one. Looks like I'm only missing the triac, will post my result once I get the new triac installed. |
| pinkman:
I recently acquired an WD1 station which works fine for a while, but ends with the degree (oF) indicator flashing and the iron OFF. Sometimes turning the unit off/on or performing a factory reset corrects this problem for a while, but it always comes back. I have tried swapping in a brand new iron and it has the same symptom, so it appears that the problem is internal. Has anyone encountered this problem? I downloaded the schematics and I'll analyze them later. I suppose it's time to start poking and prodding this little monster. |
| SLJ:
Not to sound obvious but did you check the settings for standby and auto-off time? |
| Navigation |
| Message Index |
| Next page |
| Previous page |