Electronics > Repair
Weller WD1 Discussion and Repair
<< < (6/17) > >>
M. András:
factory reset should disable the auto off and the setback timers, check the internal connections to the pcb board if its the same stupid connector as in the wd3m the type you see on the patchpanels idc or god knows whats their name can come lose if wasnt pressed in properly
pinkman:
Yup.  This fault occurs randomly, sometimes immediately after turning on (the iron never warms up).  I'm going to inspect the solder joints on everything again, they look OK but I'll inspect with a magnifier and see what I can find.


--- Quote from: SLJ on December 05, 2013, 01:26:40 pm ---Not to sound obvious but did you check the settings for standby and auto-off time?

--- End quote ---
M. András:
it easier if you remelt every joint if you have a spare iron and refit the cabling
Danielw:
Glad I found this! Thanks for the schematics

I installed a led mod like this one : http://www.eevblog.com/2012/02/03/eevblog-242-hakko-fx-888-soldering-iron-hack/
I just connected a led in series with a resistor between GND and Triac_ch1 ( I think it was, just probed around to find a good spot to solder near the connector)
Now I wont forget the damn thing turned on for a couple of days in a row!  :)
diogoc:
My soldering station have a PIC18f6622 instead the Pic18f4620.
Anyone have the firmware fot ir?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod