Electronics > Repair

Weller WD1 Discussion and Repair

<< < (7/17) > >>

nanofrog:

--- Quote from: Danielw on May 07, 2014, 03:13:35 pm ---Glad I found this! Thanks for the schematics

I installed a led mod like this one : http://www.eevblog.com/2012/02/03/eevblog-242-hakko-fx-888-soldering-iron-hack/
I just connected a led in series with a resistor between GND and Triac_ch1 ( I think it was, just probed around to find a good spot to solder near the connector)
Now I wont forget the damn thing turned on for a couple of days in a row!  :)

--- End quote ---
8)

But I have to ask, any reason to do this over looking at the switch to see if there was any red visible?  :-//

diogoc:
I get the firmware for the Weller WD2 (with PIC18f6622), so if anyone need it ask me.
With this and adding some components you can convert a WD1 into a WD2.

Smith:
I like the build and speed of these, but we had a lot of trouble with 4 older versions of the WD2M stations. Undocumented errors, spontaneous lockups one eventually killed itself. Luckely it was mine, now I have one which actually works without flaws  :-+

necplusultra:
greetings,

my WD2 has one channel saying OFF
according to manual, channel cannot be switched on. probable cause overload cut-off

is there any way to have the channel switched on?

diogoc:

--- Quote from: necplusultra on December 23, 2016, 10:58:25 am ---greetings,

my WD2 has one channel saying OFF
according to manual, channel cannot be switched on. probable cause overload cut-off

is there any way to have the channel switched on?

--- End quote ---

You can turn OFF and ON a channel in WD2.
Just press Up and Down at the same time quickly.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod