Electronics > Repair
Weller WD1 Discussion and Repair
<< < (17/17)
Matias.N:
So,
standby done. Mod stand add microswitch, solder wires to mainboard and add resistor.
All work fine.
Mr. Scram:

--- Quote from: costas on August 21, 2023, 07:33:56 pm ---Hello ,
At my Weller WD2M soldering station with a defective LCD display (missing segments), I replaced the display with one from a WE10101AN station. WE10101AN soldering stations are quite cheap, without accessories they can be found on Ebay for under $50.

--- End quote ---
Are those the same displays?
HipHopAst:
Any chance you can share what have you done to apply standby mode? Regards
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod