Electronics > Repair

Weller WD1 Discussion and Repair

<< < (17/17)

Matias.N:
So,
standby done. Mod stand add microswitch, solder wires to mainboard and add resistor.
All work fine.

Mr. Scram:

--- Quote from: costas on August 21, 2023, 07:33:56 pm ---Hello ,
At my Weller WD2M soldering station with a defective LCD display (missing segments), I replaced the display with one from a WE10101AN station. WE10101AN soldering stations are quite cheap, without accessories they can be found on Ebay for under $50.

--- End quote ---
Are those the same displays?

HipHopAst:
Any chance you can share what have you done to apply standby mode? Regards

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod