Electronics > Repair
What more i can do?
Poroit:
Please clarify which Model Iron mole you have as there are numerous models shown online.
222Lab_Test222:
--- Quote from: Poroit on November 13, 2024, 03:43:52 am ---Please clarify which Model Iron mole you have as there are numerous models shown online.
--- End quote ---
It doesnt matter because every Iron Mole has a Motherboard inside it, And 1 Motherboard controller can be used for multiple models.
If you need a specific one then TP95S-2.
The Picture Explanation
Red Lines : The things I circle with red lines is the controller box, Inside it there is a motherboard which we are diagnosing now and trying to figure out the issues going on it. We can see the control panel the buttons as well as screen.
Yellow Lines : After the screen is turn on and everything is ok, this is the program used for tunnelling the ground and many more options, which i do not have much knowledge.
Harry_22:
--- Quote from: 222Lab_Test222 on November 12, 2024, 11:02:12 pm ---
--- Quote from: Harry_22 on November 12, 2024, 07:47:29 pm ---
If the green LED is neither bright nor dim, it means it is monitoring some CLK pulses.
How does it glow on a non-working board?
--- End quote ---
It Sometimes glow so bright or sometimes the lED is not turn on.
--- End quote ---
Most likely this is CLK signal for ISA or another one.
Check and compare the signals on Clock/Data chip. Start from CLK pin
Harry_22:
Use the same method.The first channel at Reset# pin 8 MB3771 as a trigger. One power up - one trace.
222Lab_Test222:
--- Quote from: Harry_22 on November 13, 2024, 05:43:39 am ---Most likely this is CLK signal for ISA or another one.
Check and compare the signals on Clock/Data chip. Start from CLK pin
--- End quote ---
Which IC CLK pin you are referring to?
Or you referring to the CLK of Oscillators.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version