Electronics > Repair
What more i can do?
222Lab_Test222:
Everything is good BUT Look that E15 HOLD PIN.
1st Pic is Not Working.
2nd Pic is Working.
Poroit:
G'day Harry_22,
Is the OP focusing on the correct points for the signals you need to see?
It seems to me that you want him to focus on the D4990A.
I see there is a Test Pont near that IC.
BTW
My contact a Komatsu Australia can not find any details on these machines ever been brought into Australia.
222Lab_Test222:
--- Quote from: Poroit on November 14, 2024, 06:33:55 am ---
It seems to me that you want him to focus on the D4990A.
--- End quote ---
The RTC D4990A Is not performing as it should be, Everything is fine except Output. The output should be constant HIGH But It keeps fluctuating between HIGH and LOW.
222Lab_Test222:
--- Quote from: Poroit on November 14, 2024, 06:33:55 am ---BTW
My contact a Komatsu Australia can not find any details on these machines ever been brought into Australia.
--- End quote ---
Maybe it is only in JAPAN, or could be in TAIWAN And CHINA too. BUT not sure.
Harry_22:
--- Quote from: 222Lab_Test222 on November 14, 2024, 04:18:38 am ---This is Picture of CPU CLOCK and RESET PIN.
The working board and non working board is same.
1st is CLOCK and 2nd is RESET.
--- End quote ---
Well done and going in the right direction!
But the CLK and Reset# signals must be present on the working board. Check the pinout.
You will find here the Databook on 486DX2 processor
https://bitsavers.trailing-edge.com/components/intel/80486/Intel486_DX2_Microprocessor_Data_Book_Jul92.pdf
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version