Electronics > Repair
What more i can do?
<< < (41/112) > >>
222Lab_Test222:

--- Quote from: Poroit on November 18, 2024, 05:37:34 am ---
Someone also thought IC7 could be the fault.

--- End quote ---

IC7, Have not check IC7, Its an AND gate logic, data seems good.
If you want i can check again.
What you exactly need from IC7?
222Lab_Test222:

--- Quote from: Poroit on November 18, 2024, 05:37:34 am ---
"I checked all capacitor, no sign of short, the IC looking good, no burn marks as well as any damages."


--- End quote ---

First I checked physically if there is some breakage or burnt mark in capacitors.
Then I shorted the capacitor, and measure capacitance with digital multimeter.
Later someone on forum told to desolder capacitor, i desolder and measure them, seems good to me.

I have no ESR Meter.
Harry_22:

--- Quote from: 222Lab_Test222 on November 18, 2024, 12:27:18 am ---After some cleaning and resetting the CMOS Battery and shorting it, I get D Flip Flop same in Both Working and Not working one.

--- End quote ---

Hi!
Don't worry, it sometime happens.
Compare again the logic on working and non working machine.
You are lucky that have both boards to compare.
Check also the TP (test point).
222Lab_Test222:

--- Quote from: Harry_22 on November 18, 2024, 06:19:50 am ---
Compare again the logic on working and non working machine.

Check also the TP (test point).

--- End quote ---

Do you want me to check remaining pins of IC6 D Flipflop?

TP2 is negative terminal, TP1 is positive terminal, What more i should check.
They are just sorted with the power input pins.
Could it be they have some other purposes?
Harry_22:
Compare again the pins marked by green arrows. Just to shure that no difference in signals exist.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod