Electronics > Repair
What more i can do?
<< < (61/112) > >>
Sorama:

--- Quote from: fzabkar on November 23, 2024, 08:02:01 pm ---
--- Quote from: Sorama on November 23, 2024, 07:40:23 am ---
--- Quote from: fzabkar on November 23, 2024, 04:51:43 am ---The BIOS was tested on a working board. In any case, the OP is waiting for a chip programmer. Hopefully a dump will tell us something.

--- End quote ---

And did the bios of non working board worked fine in the working board?
--- End quote ---

Obviously, yes, otherwise we wouldn't be here. ;-)

--- End quote ---

If it is that obvious, why are we measuring signals if we know the bios chipset is the culprit ?
Harry_22:

--- Quote from: 222Lab_Test222 on October 29, 2024, 11:09:12 pm ---
--- Quote from: Sorama on October 29, 2024, 08:17:22 am ---the only issue is that it beeps constantly (but works apart from that) , or are there other issues?

--- End quote ---
Yes the power supply is good, There is long beep no break, I even change MSDOS as well as RAMs with new working one to check if they are fault BUT still same.

--- End quote ---
222Lab_Test222:

--- Quote from: Sorama on November 24, 2024, 12:30:39 pm ---
If it is that obvious, why are we measuring signals if we know the bios chipset is the culprit ?

--- End quote ---

BIOS is fine, I even put the working board BIOS to non working board, it still beep on non working one.
fzabkar:

--- Quote from: Sorama on November 24, 2024, 12:30:39 pm ---
--- Quote from: fzabkar on November 23, 2024, 08:02:01 pm ---
--- Quote from: Sorama on November 23, 2024, 07:40:23 am ---
--- Quote from: fzabkar on November 23, 2024, 04:51:43 am ---The BIOS was tested on a working board. In any case, the OP is waiting for a chip programmer. Hopefully a dump will tell us something.

--- End quote ---

And did the bios of non working board worked fine in the working board?
--- End quote ---

Obviously, yes, otherwise we wouldn't be here. ;-)

--- End quote ---

If it is that obvious, why are we measuring signals if we know the bios chipset is the culprit ?

--- End quote ---

If the problem is in a WACOM chip, then it's game over. AIUI, Harry_22 is trying to home in on the exact point where the problem occurs, presumably in the hope that it is caused by a support IC.
222Lab_Test222:

--- Quote from: Harry_22 on November 24, 2024, 12:07:16 pm ---
By the way, check IC23 Pin10 and Pin11 at the same 5us/div scale. As usual, working and non-working.


--- End quote ---
ok here, i see changed signal from pasts one.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod